|
APPENDIX E
WINDOWS
95 CONFIGURATION
The PCCOM 8 port adapter can be installed in the Windows 95 by using
serial device driver in the distribution diskette, and the device
driver will detect 8250, 16450, 16550, 16650 chips automatically.
E.1 Installation
1.
|
You
may set arbitrary I/O address and interrupts. However, we suggest you
use the following: |
I/O port address = 280 H
Interrupt = IRQ5
Interrupt vector = 2C0H
2.
|
Insert
the distribution diskette into floppy disk drive, then run SETUP.EXE. |
3.
|
Click
"PCCOM98 Setup Panel" to run configuration setup.
|
4.
|
Select
your card type and the correct address/IRQ value, then press [OK[.
|
5.
|
When
a dialog box presents "Setup Complete", restart Windows 95 to let
driver work.
|
If you need install more than one card, please run "PCCOM98 Setup
Panel" again. Do not set the same address and interrupt.
E.2 Remove Ports
1.
|
Enter
Windows 95.
|
2.
|
Enter [Control Panel] \
[System] \ [Device Manager] \ [Port].
|
3.
|
Select the port that you
want to remove, then press [Remove] to remove it.
|
E.3 Uninstall
1.
|
Remove
the file group and icons that created by InstallShield.
|
2.
|
Enter
[Control Panel] \ [Add/Remove Programs], select the"PCCOM98 Setup
Panel" and remove it |
|
