|
APPENDIX F
WINDOWS
2000 CONFIGURATION
The PCCOM 4 port adapter can be
installed in the Windows 2000 by using serial device driver in the
distribution CD, and the device driver will detect 8250, 16450, 16550,
16650 chips automatically.
F.1 Installation
| 1. |
Unplug
your PC, open it and install one Decision PCCOM card. |
2.
|
Start
your computer and wait until Windows 2000 is loaded. |
3.
|
Insert
the device driver CD into your computer, and make sure Windows
2000 finds the drivers by eventually browsing through the directory
structure of the CD. |
4.
|
For
manual installation run SETUP.EXE under the START BUTTON \ RUN \ BROWSE
on the CD-ROM directory DECISION \ WINDOWS \ WINDOWS2000 \ PCCOM \
DRIVER or
use windows explorer, then look for the file SETUP.EXE on the said
directory |
5.
|
After
the installation process, go to CONTROL PANEL \ DECISION PCCOM
ADAPTERS \ ADD button, set the corresponding settings according to your
hardware settings before, then click OK. The software will tell you if
there is any conflict in the settings, if conflict occur, you may
change jumper settings or the software setting by the CONTROL
PANEL \ DECISION PCCOM ADAPTERS |
|
|
F
|
If
you need install more than one card, please run above procedure
again. Never try to install 2 or more cards at the same time for you
will have errors in installation. |
F.2 Remove Ports
1.
|
Go to
[Control Panel Applet]\[Decision PCCOM Adapters]. |
2.
|
Select the port you want
to remove then press ˇ§Remove Portˇ¨ to delete specified port. Reboot for
changes to take effect. |
ˇ@
|
