APPENDIX E
WINDOWS 95 CONFIGURATION
The PCCOM 4 port adapter can be
installed in the Windows 95 by using serial device driver in the
distribution diskette, and the device driver will detect 8250, 16450,
16550, 16650 chips automatically.
E.1 Installation
| 1. |
You may set arbitrary I/O address and interrupts. However, we suggest you use the following: |
Enhance Mode
I/O port address = 2A0H
Interrupt = IRQ5
I/O port address = 2A0H
Interrupt = IRQ5
| 2. |
Insert the distribution diskette into floppy disk drive, then runSETUP.EXE. |
| 3. |
Click "PCCOM98 Setup Panel" to run configuration setup. |
| 4. |
Select our card type and the correct address/IRO value, then press [OK]. |
| 5. |
When a dialog box presents "Setup CompleteP, restart Windows 95 to let driver work. |
If you need install more than
one card, please run "PCCOM98 Setup Panel" again. Do not set the same
address and interrupt.
E.2 Remove Ports
| 1. |
Enter Windows 95. |
| 2. |
Enter[Control Panel] \ [Setup] \ [Device Manager] \ [Ports]. |
| 3. |
Select the port that you want to remove, then press [Remove] to remove it. |
E.3 Uninstall
| 1. |
Remove the file group and icons that created by InstallShield. |
| 2. |
Enter [Control Panel] \ [Add/Remove Programs], select the "PCCOM98 Setup Panel" and remove it. |
