APPENDIX G
WINDOWS/NT CONFIGURATION For version 3.51 up
The PCCOM 2 port adapter can be
installed in the Windows NT by using serial device driver in the
distribution diskette, and the device driver will detect 8250, 16450,
16550, 16650 chips automatically.
G.1 Installation
| 1. |
You may set arbitrary I/O address and interrupts. However, we suggest you use the following: |
| 2. |
Insert the distribution diskette into floppy disk drivethen run SETUP.EXE. |
| 3. |
Click "PCCOM98 Setup Panel" to run configuration setup. |
| 4. |
Select your card type and the correct address/IRQ value, then press [OK]. |
| 5. |
When a dialog box presents "Setup Complete", restart Windows 95 to let driver work. |
net stop
serial
// stop the origin driver
net start serial // start our new driver
net start serial // start our new driver
thenour driver driver will start
to work.
| 6. |
The
COM1 to COM9 can be directly referenced just like a filename from
program and from the command line. However, COM10 and above must be
referenced with the following syntax: |
\\.\com10
Because the command line mode doesn't recognize ports above COM9.
| 7. |
Don't
overlap port address and intertupt vector address, otherwise, it
maconflict with UART chips. |
| 8. |
If
you need install more than one card, please run "PCCOM98 Setup Panel"
again. Do not set the same address and interrupt. |
G.2 Remove Ports
| 1. |
Enter Windows NT. |
| 2. |
Enter [Control Panel] \ [Ports]. |
| 3. |
Select
the port to delete. |
G.3 Uninstall
| 1. |
Remove the file group and icons that created by InstallShield. |
| 2. |
Enter [Control Panel] \ [Add/Remove Programs], select the "PCCOM98 Setup Panel" and remove it. |
