APPENDIX E
WINDOWS95 CONFIGUR ATION
The PCCOM 2 port adapter can be
installed in the Windows 95/98 by using serial device driver in the
distribution diskette, and the device driver will detect 8250, 16450,
16550, 16650 chips automatically.
E.1 Installation
| 1. |
You may set arbitrary I/O address and interrupts. However, we suggest you use the following: |
| 2. |
Insert the distribution diskette into floppy disk drivethen run SETUP.EXE. |
| 3. |
Click "PCCOM98 Setup Panel" to run configuration setup. |
| 4. |
Select your card type and the correct address/IRQ value, then press [OK]. |
| 5. |
When a dialog box presents "Setup Complete", restart Windows 95 to let driver work. |
If you need install more than
one card, please run "PCCOM98 Setup Panel" again. Do not set the same
address and interrupt.
E.2 Remove Ports
| 1. |
Enter Windows 95. |
| 2. |
Enter [Control Panel] \ [System] \ [Device Manager] \ [Ports]. |
| 3. |
Select the port that you want to remove, then press [Remove] to remove it. |
E.3 Uninstall
| 1. |
Remove the file group and icons that created by InstallShield. |
| 2. |
Enter [Control Panel] \ [Add/Remove Programs], select the "PCCOM98 Setup Panel" and remove it. |
