APPENDIX E
WINDOWS95 CONFIGUR ATION


The PCCOM 2 port adapter can be installed in the Windows 95 by using RS422 serial device driver in the distribution diskette, and the device driver will detect 8250, 16450, 16550, 16650 chips automatically.

E.1 Installation

1.
 You may set arbitrary I/O address and interrupts. However, we suggest you use the following:


2.
 Insert the distribution diskette into floppy disk drivethen run SETUP.EXE.
3.
 Click "PCCOM98 Setup Panel" to run configuration setup.
4.
 Select your card type and the correct address/IRQ value, then press [OK].
5.
 When a dialog box presents "Setup Complete", restart Windows 95 to let driver work.

If you need install more than one card, please run "PCCOM98 Setup Panel" again. Do not set the same address and interrupt.


E.2 Remove Ports

1.
 Enter Windows 95.
2.
 Enter [Control Panel] \ [System] \ [Device Manager] \ [Ports].
3.
 Select the port that you want to remove, then press [Remove] to remove it.


E.3 Uninstall

1.
 Remove the file group and icons that created by InstallShield.
2.
 Enter [Control Panel] \ [Add/Remove Programs], select the "PCCOM98 Setup Panel" and remove it.